/* Network configuration commands */
{"===== network config =====", jt_noop, 0, "network config"},
- {"--net", jt_opt_net, 0,"run <command> after setting network to <net>\n"
- "usage: --net <tcp/elan/o2ib/...> <command>"},
- {"network", jt_ptl_network, 0, "configure LNET"
- "usage: network up|down"},
- {"net", jt_ptl_network, 0, "configure LNET"
- "usage: net up|down"},
- {"list_nids", jt_ptl_list_nids, 0, "list local NIDs"
- "usage: list_nids [all]"},
- {"which_nid", jt_ptl_which_nid, 0, "choose a NID"
- "usage: which_nid NID [NID...]"},
+ {"--net", jt_opt_net, 0, "run <command> after selecting network <net>\n"
+ "usage: --net <tcp/o2ib/...> <command>"},
+ {"network", jt_ptl_network, 0, "configure LNET"
+ "usage: network up|down"},
+ {"net", jt_ptl_network, 0, "configure LNET"
+ "usage: net up|down"},
+ {"list_nids", jt_ptl_list_nids, 0, "list local NIDs"
+ "usage: list_nids [all]"},
+ {"which_nid", jt_ptl_which_nid, 0, "choose a NID"
+ "usage: which_nid NID [NID...]"},
{"replace_nids", jt_replace_nids, 0,
"replace primary NIDs for a device\n"
"usage: replace_nids <device> <nid1>[,nid2,nid3]"},
- {"interface_list", jt_ptl_print_interfaces,0,"print interface entries\n"
- "usage: interface_list"},
- {"peer_list", jt_ptl_print_peers, 0, "print peer entries\n"
- "usage: peer_list"},
- {"conn_list", jt_ptl_print_connections, 0,
- "print all the connected remote nid\n"
- "usage: conn_list"},
- {"route_list", jt_ptl_print_routes, 0,
- "print the portals routing table, same as show_route\n"
- "usage: route_list"},
- {"show_route", jt_ptl_print_routes, 0,
- "print the portals routing table, same as route_list\n"
- "usage: show_route"},
- {"ping", jt_ptl_ping, 0, "Check LNET connectivity\n"
- "usage: ping nid [timeout] [pid]"},
+ {"interface_list", jt_ptl_print_interfaces, 0,
+ "print network interface entries\n"
+ "usage: interface_list"},
+ {"peer_list", jt_ptl_print_peers, 0, "print peer LNet NIDs\n"
+ "usage: peer_list"},
+ {"conn_list", jt_ptl_print_connections, 0,
+ "print all the remote LNet connections\n"
+ "usage: conn_list"},
+ {"route_list", jt_ptl_print_routes, 0,
+ "print the LNet routing table, same as show_route\n"
+ "usage: route_list"},
+ {"show_route", jt_ptl_print_routes, 0,
+ "print the LNet routing table, same as route_list\n"
+ "usage: show_route"},
+ {"ping", jt_ptl_ping, 0, "Check LNET connectivity\n"
+ "usage: ping nid [timeout] [pid]"},
{"net_drop_add", jt_ptl_drop_add, 0, "Add LNet drop rule\n"
"usage: net_drop_add <-s | --source NID>\n"
" <-d | --dest NID>\n"
"usage: conf_param [-d] <target.keyword=val>\n"
" -d Remove the permanent setting."},
#endif
- {"local_param", jt_lcfg_param, 0, "set a temporary, local param\n"
- "usage: local_param <target.keyword=val>\n"},
- {"get_param", jt_lcfg_getparam, 0, "get the Lustre or LNET parameter\n"
- "usage: get_param [-n|-N|-F] <param_path1 param_path2 ...>\n"
- "Get the value of Lustre or LNET parameter from the specified path.\n"
- "The path can contain shell-style filename patterns.\n"
- " -n Print only the value and not parameter name.\n"
- " -N Print only matched parameter names and not the values.\n"
- " (Especially useful when using patterns.)\n"
- " -F When -N specified, add '/', '@' or '=' for directories,\n"
- " symlinks and writeable files, respectively."},
- {"set_param", jt_lcfg_setparam, 0, "set the Lustre or LNET parameter\n"
+ {"local_param", jt_lcfg_param, 0, "set a temporary, local param\n"
+ "usage: local_param <target.keyword=val>\n"},
+ {"get_param", jt_lcfg_getparam, 0, "get the Lustre or LNET parameter\n"
+ "usage: get_param [-F|n|-N|-R] <param_path1 param_path2 ...>\n"
+ "Get the value of Lustre or LNET parameter from the specified path.\n"
+ "The path can contain shell-style filename patterns.\n"
+ " -F When -N specified, add '/', '@' or '=' for directories,\n"
+ " symlinks and writeable files, respectively.\n"
+ " -n Print only the value and not parameter name.\n"
+ " -N Print only matched parameter names and not the values.\n"
+ " (Especially useful when using patterns.)\n"
+ " -R Get parameters recursively from the specified entry.\n"},
+ {"set_param", jt_lcfg_setparam, 0, "set the Lustre or LNET parameter\n"
"usage: set_param [-n] [-P] [-d]"
"<param_path1=value1 param_path2=value2 ...>\n"
"Set the value of the Lustre or LNET parameter at the specified path.\n"
"usage: nodemap_del <nodemap_name>"},
{"nodemap_add_range", jt_nodemap_add_range, 0,
"add a range to a nodemap\n"
- "usage: nodemap_add_range <NID range>"},
+ "usage: nodemap_add_range <nid_range>"},
{"nodemap_del_range", jt_nodemap_del_range, 0,
"add a range to a nodemap\n"
- "usage: nodemap_del_range <NID range>"},
+ "usage: nodemap_del_range <nid_range>"},
{"nodemap_modify", jt_nodemap_modify, 0,
"modify a nodemap parameters"
"usage: nodemap_modify nodemap_name param value"},
"disable writes to the underlying device\n"},
{"notransno", jt_obd_no_transno, 0,
"disable sending of committed-transno updates\n"},
- {"add_uuid", jt_lcfg_add_uuid, 0, "associate a UUID with a nid\n"
- "usage: add_uuid <uuid> <nid>"},
- {"del_uuid", jt_lcfg_del_uuid, 0, "delete a UUID association\n"
- "usage: del_uuid <uuid>"},
- {"add_peer", jt_ptl_add_peer, 0, "add an peer entry\n"
- "usage: add_peer <nid> <host> <port>"},
- {"del_peer", jt_ptl_del_peer, 0, "remove an peer entry\n"
- "usage: del_peer [<nid>] [<ipaddr|pid>]"},
- {"add_conn ", jt_lcfg_add_conn, 0,
- "usage: add_conn <conn_uuid> [priority]\n"},
- {"del_conn ", jt_lcfg_del_conn, 0,
- "usage: del_conn <conn_uuid> \n"},
- {"disconnect", jt_ptl_disconnect, 0, "disconnect from a remote nid\n"
- "usage: disconnect [<nid>]"},
- {"push", jt_ptl_push_connection, 0, "flush connection to a remote nid\n"
- "usage: push [<nid>]"},
- {"mynid", jt_ptl_mynid, 0, "inform the socknal of the local nid. "
- "The nid defaults to hostname for tcp networks and is automatically "
- "setup for elan/myrinet networks.\n"
- "usage: mynid [<nid>]"},
- {"fail", jt_ptl_fail_nid, 0, "fail/restore communications.\n"
- "Omitting the count means indefinitely, 0 means restore, "
- "otherwise fail 'count' messages.\n"
- "usage: fail nid|_all_ [count]"},
+ {"add_uuid", jt_lcfg_add_uuid, 0, "associate a UUID with a NID\n"
+ "usage: add_uuid <uuid> <nid>"},
+ {"del_uuid", jt_lcfg_del_uuid, 0, "delete a UUID association\n"
+ "usage: del_uuid <uuid>"},
+ {"add_peer", jt_ptl_add_peer, 0, "add an peer entry\n"
+ "usage: add_peer <nid> <host> <port>"},
+ {"del_peer", jt_ptl_del_peer, 0, "remove an peer entry\n"
+ "usage: del_peer [<nid>] [<ipaddr|pid>]"},
+ {"add_conn ", jt_lcfg_add_conn, 0,
+ "usage: add_conn <conn_uuid> [priority]\n"},
+ {"del_conn ", jt_lcfg_del_conn, 0,
+ "usage: del_conn <conn_uuid>"},
+ {"disconnect", jt_ptl_disconnect, 0, "disconnect from a remote NID\n"
+ "usage: disconnect [<nid>]"},
+ {"push", jt_ptl_push_connection, 0, "flush connection to a remote NID\n"
+ "usage: push [<nid>]"},
+ {"mynid", jt_ptl_mynid, 0, "inform the LND of the local NID. "
+ "The NID defaults to hostname for TCP networks.\n"
+ "usage: mynid [<nid>]"},
+ {"fail", jt_ptl_fail_nid, 0, "fail/restore network communications\n"
+ "Omitting the count means indefinitely, 0 means restore, "
+ "otherwise fail 'count' messages.\n"
+ "usage: fail nid|_all_ [count]"},
/*Test commands for echo client*/
{"test_create", jt_obd_test_create, 0,
{"test_brw", jt_obd_test_brw, 0,
"do <num> bulk read/writes (<npages> per I/O, on OST object <objid>)\n"
"usage: test_brw [t]<num> [write [verbose [npages [[t]objid]]]]"},
- {"memhog", jt_ptl_memhog, 0,
- "memory pressure testing\n"
- "usage: memhog <page count> [<gfp flags>]"},
{"getobjversion", jt_get_obj_version, 0,
"get the version of an object on servers\n"
"usage: getobjversion <fid>\n"
{"del_interface", jt_ptl_del_interface, 0, "del interface entry\n"
"usage: del_interface [ip]"},
{"add_route", jt_ptl_add_route, 0,
- "add an entry to the portals routing table\n"
+ "add an entry to the LNet routing table\n"
"usage: add_route <gateway> [<hops> [<priority>]]"},
{"del_route", jt_ptl_del_route, 0,
- "delete route via gateway to targets from the portals routing table\n"
+ "delete route via gateway to targets from the LNet routing table\n"
"usage: del_route <gateway> [<target>] [<target>]"},
{"set_route", jt_ptl_notify_router, 0,
- "enable/disable routes via gateway in the portals routing table\n"
+ "enable/disable routes via gateway in the LNet routing table\n"
"usage: set_route <gateway> <up/down> [<time>]"},
{ 0, 0, 0, NULL }
setlinebuf(stdout);
- ptl_initialize(argc, argv);
+ if (ptl_initialize(argc, argv) < 0)
+ exit(1);
if (obd_initialize(argc, argv) < 0)
exit(2);
if (dbg_initialize(argc, argv) < 0)
git://git.whamcloud.com / fs / lustre-release.git / blobdiff