X-Git-Url: https://git.whamcloud.com/?a=blobdiff_plain;f=InstallOverview.xml;h=223daa52d708f8ca7aa68e16dcc9df10ccb41ecf;hb=30dbf01c7386a9514d618281526d78fdea92db6b;hp=094372ef5a50bebb096804c3cc3b6d9b21e87b04;hpb=d20446f6e1ede7f3a23e27c3bd195275e91a3cc9;p=doc%2Fmanual.git
diff --git a/InstallOverview.xml b/InstallOverview.xml
index 094372e..223daa5 100644
--- a/InstallOverview.xml
+++ b/InstallOverview.xml
@@ -2,17 +2,21 @@
Installation Overview
This chapter provides on overview of the procedures required to set up, install and configure a Lustre file system.
-
- If you are new to Lustre, you may find it helpful to refer to for a description of the Lustre architecture, file system components and terminology before proceeding with the installation procedure.
+ If the Lustre file system is new to you, you may find it helpful to refer to for a description of the Lustre architecture, file system components
+ and terminology before proceeding with the installation procedure.
- installing
- Steps to Installing Lustre
+
+ installing
+ Steps to Installing the Lustre Software
To set up Lustre file system hardware and install and configure the Lustre software, refer the the chapters below in the order listed:
- (Required) Set up your Lustre file System hardware.
+
+ (Required)
+ Set up your Lustre file system hardware.
See - Provides guidelines for configuring hardware for a Lustre file system including storage, memory, and networking requirements.
@@ -28,19 +32,23 @@
See - Describes preparation steps and a procedure for installing the Lustre software.
- (Optional) Configure Lustre Networking (LNET).
- See - Describes how to configure LNET if the default
- configuration is not sufficient. By default, LNET will use the first TCP/IP interface it
- discovers on a system. LNET configuration is required if you are using InfiniBand or
+ (Optional)
+ Configure Lustre Networking (LNet).
+ See - Describes how to configure LNet if the default
+ configuration is not sufficient. By default, LNet will use the first TCP/IP interface it
+ discovers on a system. LNet configuration is required if you are using InfiniBand or
multiple Ethernet interfaces.
- (Required) Configure Lustre.
+ (Required)
+ Configure the Lustre file system.
See - Provides an example of a simple Lustre configuration procedure and points to tools for completing more complex configurations.
- (Optional) Configure Lustre Failover.
- See - Describes how to configure Lustre failover using the Heartbeat cluster infrastructure daemon.
+ (Optional)
+ Configure Lustre failover.
+ See - Describes how to configure Lustre
+ failover.